BP110UVFR-S2MP Fireye Burner Control

Overview

The Fireye BP110UVFR-S2MP BurnerPRO is a compact, microprocessor-based primary flame safeguard control system designed for industrial and commercial burner management. It provides precise burner sequencing, ignition, and continuous flame monitoring for on-off, multi-stage, or modulating burners firing oil or gas fuels. This model features integrated Modbus communication and Valve Proving (VP) logic, offering a modern, non-volatile electronic replacement for older electro-mechanical controls like the Siemens LFL. It is equipped with two built-in amplifiers, supporting UV non-self-check scanners, flame rods, or a combination of both.

Features

• Integrated Modbus RTU communication for remote monitoring and data access.
• Built-in Valve Proving (VP) system to check the integrity of safety shut-off valves.
• Dual amplifier support (UV, FR, or UV+FR) provides application flexibility.
• Smart LED interface consisting of seven LEDs to indicate operating status and diagnostic lockout codes.
• Non-volatile lockout capability ensures safety by requiring a manual reset after a shutdown, even after power loss.
• Run/Check feature allows operators to pause the program sequence at specific points (Purge, Ignition, PTFI, MTFI) for troubleshooting.
• Drop-in compatibility with Siemens LFL wiring bases, simplifying system upgrades.
• Real-time internal diagnostics and self-test performed on every start-up for enhanced safety integrity.

Specifications

• Model Number: BP110UVFR-S2MP
• Supply Voltage: 110 VAC (+20%, -15%) 50/60 Hz
• Power Consumption: 7 VA
• Timings: Series 2 factory-set timing sequence
• Operating Temperature Range: -40 degrees C to +60 degrees C (-40 degrees F to 140 degrees F)
• Humidity: 90 percent RH (non-condensing)
• Protection Category: IP40
• Flame Failure Response Time (FFRT): 1 second
• Compatible Scanners: UV90L, UV1AL, and UV5 for ultraviolet detection; 69ND1 for flame rod (ionization) applications.

Applications

The BurnerPRO BP110UVFR-S2MP is ideally suited for commercial and industrial heating and process equipment. It is commonly used in boiler rooms, oil refineries, petrochemical plants, and power generation facilities. Because the UV operation is non-self-checking, it is designed for non-permanent operation where the burner is recycled at least once every 24 hours. The flame rod (FR) amplifier is self-checking and can be used for continuous operation. It is an ideal solution for upgrading legacy Siemens LFL or Honeywell 7800 series installations with modern microprocessor-based technology.