BP110UV-S2 Fireye Burner Control

Overview

The Fireye BP110UV-S2 is a compact, microprocessor-based BurnerPRO single burner control designed to provide proper burner sequencing, automatic ignition, and continuous flame monitoring. It serves as a primary flame safeguard system for commercial heating and process equipment. This model is specifically engineered for use with 110VAC power and utilizes Series 2 factory-set operational timings. It is often used as a plug-and-play retrofit solution for Siemens LFL1.333-110V controls, utilizing existing wiring bases without requiring external changes.

Features

• Microprocessor-based integrated burner management control for enhanced reliability.
• Built-in UV non-self-check amplifier for flame monitoring.
• Non-volatile lockout capability ensures safety by maintaining lockout status even after a power loss.
• Seven SMART LEDs provide real-time operating status and diagnostic lockout information.
• Run/check feature allows operators to stop the program sequence at specific positions (Purge, Ignition, PTFI, MTFI) for troubleshooting.
• One second flame failure response time (FFRT) for rapid safety shutdown.
• Supports both remote and local manual reset.
• High-capacity relay contacts for direct control of burner components.

Specifications

• Model Number: BP110UV-S2
• Supply Voltage: 110 VAC (+20%, -15%) at 50/60Hz
• Power Consumption: 7 VA
• Operating Temperature: -40 degrees C to +60 degrees C (-40 degrees F to 140 degrees F)
• Humidity: 90 percent RH (non-condensing)
• Protection Category: IP40
• Timings: Series 2 operational timings
• Weight: Approximately 2.5 lbs (1.13 kg)
• Compatibility: Designed for Fireye 60-2981-1 and select Siemens LFL wiring bases.

Applications

The BP110UV-S2 is primarily used in commercial and industrial combustion systems, including single burner commercial heating equipment and industrial boilers firing oil and gas fuels. It is suitable for a variety of applications such as process burners, pilot burners, duct burners, and waste gas units. Due to its non-self-check design, it is intended for use in non-permanent operations that require the burner to recycle at least once every 24 hours.